User's Manual

Getting Started
Preparing your NAVIGON 21MAX for use
8 NAVIGON 21MAX User’s Guide March 2008
NAVIGON, INC.
Preparing your NAVIGON 21MAX for use
Use the navigation system at your own risk.
Charging the battery
• Connect the car charger cable to the navigation device and to the vehicle’s ciga-
rette lighter.
The LED of the
NAVIGON 21MAX indicates the current battery charge. The LED
lights:
• No light, the battery is flat.
• Orange during charging.
• Green when the battery is fully charged.
Inserting a memory card
The SD memory card contains maps and navigation software. It also stores saved
destinations, routes, and logbook entries.
• Insert the memory card provided into the slot on the side of the device. Press the
card into the device until it locks into place.
Removing the memory card
1. Switch the navigation device to Standby by pressing the (On/Standby) switch
for at least 6 seconds.
2. Press the memory card gently into the device until the lock disengages.
The card pops up slightly.
3. Gently slide the card out of the slot.
Caution!
Please be sure to see the safety information in “Important safety information”
on page 6.
Note: It takes approximately 6 hours to charge the device when the battery is flat.
A fully charged battery provides up to 3.5 hours of use.