Operation Manual

Response

By default the system switches between HI/LO parameter set based on speed (motor boats)

or speed and wind (sail boats). You can however select to manually set which parameter set

that shall be used.

HI or LO must be selected if no speed input is available.

You can manually fine tune each of the two (HI/LO) parameter sets. Level 4 is default with

parameter values as set by the autotune function. If no autotune is made (not

recommended) the level 4 values are the factory default values.

A low response level reduces the rudder activity and provides a more “loose” steering.

A high response level increases the rudder activity and provides a more “tight” steering. A too

high response level will make the boat start S-ing.

Automatic steering

This option displays an overview of all autopilot steering parameters, and you can adjust

parameters if required.

For more details, refer to the separate NSS evo2 Installation manual.

Installation

Used for autopilot installation and commissioning. See the separate NSS evo2 Installation

manual.

Autopilot | NSS evo2 Operator Manual