Installation Manual

4 HS35 Handset installation
1. Choose a suitable location that ensures sufficient room is allocated to allow the HS35
handset to fit securly in the charging bracket.
2. Hold the supplied mounting bracket at the chosen location and use a soft pencil to
mark the 3 screw holes and 1 wire hole positions onto the mounting surface.
3. Drill the 3 screw holes ( 4.0 mm) and 1 wire hole ( 3.5mm) where marked. Drill
completely through the mounting surface.
Note: If you are drilling into fiberglass, use a small drill bit to drill pilot holes before drill-
ing the screw holes.
4. Feed the DC connection wire through the wire hole (lower hole).
5. Use the flat screws, spring washers, plain washers, and nuts to attach the mounting
bracket to the location site OR, if you cannot reach behind the mounting surface to
attach the nuts, use the self-tapping screws instead of the flat screws.
6. Connect the DC connection wire to a 12V DC source via a 1A fuse.
Red wire to battery (+), Black wire to battery (-).
Drill 1 x 3.5mm
Wire hole
Drill 3 x 4.0mm
mounting holes
Simrad - RS35 Installation Instructions18 Simrad - RS35 Installation Instructions 19