User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
26
2. If this is the first time that you are entering your ATIS MMSID, a dashed line
appears. Enter your ATIS MMSID here and select STORE. The first number is
always 9.
If you are editing an existing ATIS MMSID, this will be displayed. Make the
required changes.
3. Input the ATIS MMSID again as a check. Press ENT and select SAVED.
If the user MMSID has been entered correctly both times, it is displayed for
3 seconds on screen and then stored.
4.5.2 ENABLE ATIS FUNCTIONALITY (ATIS FUNC)
7100 EC only. ATIS functionality will operate only after the ATIS MMSID has
been entered (see previous section).
1. Select DSC SETUP, then ATIS
FUNC.
2. Select ON to enable the ATIS
functionality and automatically
disable DSC functionality.
A warning message will appear:
WARNING DSC OFF.
(Note that it is not possible to have both ATIS ON and DSC ON simultaneously.
When you enable one, the transceiver will automatically disable the other and
display a warning message.)
4.6 DSC FUNCTIONALITY OPTIONS (DSC FUNC)
DSC functionality can be disabled but this is not recommended.
1. Select DSC SETUP, then DSC
SCAN.
2. Select ON to operate the
DSC functionality. (This will
automatically disable ATIS
functionality on the 7100 EC and
a warning message will appear:
WARNING ATIS OFF.)
(Note that it is not possible to have both ATIS ON and DSC ON simultaneously
on the 7100 EC. When you enable one, the transceiver will automatically
disable the other and display a warning message.)
4.7 RESPONSE TYPE TO LL CALLS (LL REPLY)
You can set up the VHF 7100 to respond to an LL request in one of four ways.
AUTO - automatically reply to any incoming LL request.
AUTO BUDDY - automatically reply to any incoming call
from anyone in your buddy list or a group list.
MANUAL - choose whether to reply or not.
OFF - switch off notification of any incoming LL requests.