User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
20
4. Select YES to confirm the new channel name tag.
Delete a channel name as follows:
1. Select RADIO SETUP, then select CH NAME.
2. Use + or - to step through the channels with their name tags until you see
the channel name tag you want to change. In this example, the PHONETALK
name tag associated with CH02 is deleted.
3. Select DELETE and press ENT.
4. Select YES to confirm the deletion. The channel is shown with no name tag.
3.3 RING & BEEP VOLUME (RING VOLUME) & (BEEP VOLUME)
Set the volume level of the incoming signal beeps (RING VOLUME) and/or
the error and warning beeps (BEEP VOLUME) to HIGH (high) or LOW (low) as
follows:
1. Select RADIO SETUP, then select RING VOLUME or BEEP VOLUME as
appropriate.
2. Select HIGH or LOW. (The beeps will sound at the new level.)
3.4 INTERNAL SPEAKER CONNECTIONS (INTERNAL SPK)
If any internal speakers are connected to the VHF radio, use this menu option
to switch them on or off to suit your cabin arrangements.