User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
18
If the GPS Simulator is turned on, the simulated speed, bearing, and LL
positions appear on the LCD as:
7100 EC
11 knots moving 045º
50º 30.000N,
00º 00.000E
7100 USA
11 knots moving 045º
25º 00.000N
82º 00.000W
This data is updated automatically during the simulation.
Note that it is not possible to send a transmission when in simulator mode.
2.7 RESET TO FACTORY DEFAULTS (RESET)
Use this to return every setting to the factory defaults except your user MMSID
and the entries in your buddy list. (new picture)
1. Select RESET, then select YES.