User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
17
(SOG) data on the LCD.
1. Select GPS/DATA, then SETTING.
2. Select COG/SOG.
2. Select ON (on) or OFF (off) as desired. In this example, ON has been selected
and so the LCD shows the bearing and speed.
If GOG/SOG is set ON, the time is not displayed on the LCD (see section
2.6.4).
2.5.7 GPS ALARM OPTIONS (ALARM)
7100 USA and 7100 EC only.
The GPS Alarm is usually set to ON so that if the GPS navigation receiver is
disconnected, the alarm sounds.
1. Select GPS/DATA, then SETTING.
2. Select ALARM.
2. Select ON (on) or OFF (off) as desired.
2.6 GPS SIMULATOR (SIMULATOR)
The GPS Simulator is usually set to OFF. However, if you want to test it, turn it
on. (new pictures)
1. Select SIMULATOR, then select ON (on) or OFF (off) as desired.