User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
16
1. Select GPS/DATA, then SETTING.
2. Select LL DISPLAY.
2. Select ON (on) or OFF (off) as desired. In this example, OFF has been
selected and so the LCD no longer shows the vessel position.
2.5.4 TIME DISPLAY OPTIONS (TIME DISPLAY)
If you have entered the time manually as described in the previous sections,
the time is always shown on the LCD with the prefix M.
However, if the vessel position is being updated through a GPS navigation
receiver, you can switch the time display on the LCD on or off as follows:
1. Select GPS/DATA, then SETTING.
2. Select TIME DISPLAY.
2. Select ON (on) or OFF (off) as desired. In this example, OFF has been
selected and so the LCD no longer shows the time.
If the time display is set ON, course and speed data are not displayed on the
LCD (see section 2.6.6).
2.5.5 TIME FORMAT OPTIONS (TIME FORMAT)
Time can be shown in 12 or 24 hour format.
1. Select GPS/DATA, then SETTING.
2. Select TIME FORMAT.
2. Select 12 Hr or 24 Hr as desired. In this example, 12 hour format has been
selected and so the LCD shows the am or pm suffix.
2.5.6 COURSE & SPEED DISPLAY OPTIONS (COG/SOG)
Use this option to display course over ground (COG) and speed over ground