User's Manual
Table Of Contents
- Chapter 1 - General Information
- Chapter 2 - The Radio Menu (MENU)
- Chapter 3 - Radio Setup Menu (RADIO SETUP)
- Chapter 4 - DSC Setup Menu (DSC SETUP)
- Chapter 5 - Sending and Receiving DSC Calls
- 5.1 WHAT IS DSC?
- 5.2 Sending dsc calls
- 5.2.1 Make a Routine Call MANUALLY (INDIV REPLY)
- 5.2.2 Retrying a Routine Call
- 5.2.3 ACKNOWLEDGE AN INDIVIDUAL CALL (INDIV ACK)
- 5.2.4 Recall the Most Recent INCOMING Call (LAST)
- 5.2.5 Call a Group (GROUP)
- 5.2.6 Call All Ships (ALL SHIPS)
- 5.2.7 CALL Using the Call Log (CALL LOG)
- 5.2.8 CALL using the distress log (DISTRES LOG)
- 5.3 receiving dsc calls
- Chapter 6 - Distress Calls
- Appendix A - Technical Specifications
- Appendix B - Troubleshooting
- Appendix C - VHF Marine Channel Charts
- Appendix D - MMSID & License Information
10
When a signal is received, scanning stops at that channel and
BUSY appears on the LCD. If the signal ceases for more than 5
seconds, the scan restarts.
Press ENT to skip over (lock out) a busy channel when in ALL
SCAN mode and resume the scan. An X is shown on the LCD to
designate a skipped channel. Note that it is not possible to skip
over the priority channel.
Press SCAN to stop at the current channel.
+ CH - Channel Select. Also on the microphone. The current channel
is shown on the LCD with any suffix (such as A or B) in small
letters below the channel number.
Press + or - to step through the available channels one at a
time, or hold down to scroll rapidly through all the available
channels. See Appendix C for a complete listing of channel
charts.
Alphanumeric Entry. This key can also be used for menu
selection and for alphanumeric entry. Press + or - to scroll the
cursor up or down menu options when navigating menus.
To enter numbers, press + to count through the numbers or
hold down to scroll rapidly to the desired number.
To enter a character, press - to step through the alphabet or
hold down to scroll rapidly to the desired character.
ENT Enter. Use ENT when navigating menus, to confirm entries and
edits.
ESC Escape. Use ESC when navigating menus, to clear incorrect
entries, to exit from a menu without saving changes, and to
back up to the previous screen.
CALL/MENU DSC Setup Menu and DSC Call Menu. 7100 USA and 7100 EC
only. Press to enter the DSC Call Menu and make DSC calls. See
Chapter 5.
Hold down to enter the DCS Setup Menu and customize your
NAVMAN VHF radio. See Chapter 4.
MENU Radio menu. 7000 only. Press to enter the Radio Menu and
customize your NAVMAN VHF radio. See Chapter 3.
DISTRESS Send a DSC Distress Call. 7100 USA & 7100 EC only. See
Chapter 6.
PTT Press To Talk. Press PTT to transmit at any time. This
automatically exits you from menu mode. You must release
PTT to receive a signal.
If PTT sticks, a built-in timer will automatically shut down a
transmission after five minutes and sound the error beeps.
If you have a USA 7100, note that PTT will not operate if you are
in WX mode.