Installation Manual

8
Simrad - RS35 & HS35 Installation Instructions
2.3.1 Mounting bracket installation
1. Hold the supplied mounting bracket at the chosen location and use a soft pencil t o
mark the 4 screw hole positions onto the mounting sur face .
2. Drill the 4 screw holes where mar k ed . Drill completely through the mounting sur face .
Note: If you are drilling into fiber glass , use a small drill bit to drill pilot holes before drill-
ing
the screw holes .
3. Use the flat scr ews , spring washers , plain washers , and nuts to attach the mounting
bracket to the location site OR, if you cannot reach behind the mounting surface t o
attach the nuts , use the self-tapping screws instead of the flat scr ews .
4. Slide the radio into the mounting bracket.
5. I nser t the 2 mounting knobs through the holes and tighten them sufficiently to hold
the radio at your preferred viewing angle .
6. You can adjust the viewing angle at any time . The viewing angle has a 20º tilt range .
7. Now install the microphone wall hanger .