Installation Manual

18
Simrad - RS35 & HS35 Installation Instructions
4 HS35 Handset installation
Drill 3 x 04.0mm
mounting holes
122.0mm
[4.80]
Drill 1 x 03.5mm
Wire hole
13.0mm
[0.51]
1. Choose a suitable location that ensures sufficient room is allocated to allow the HS35
handset
to fit securly in the charging bracket.
2. Hold the supplied mounting bracket at the chosen location and use a soft pencil t o
mark the 3 screw holes and 1 wire hole positions onto the mounting sur face .
3. Drill the 3 screw holes (0 4.0 mm) and 1 wire hole (0 3.5mm) where mar k ed . Drill
completely through the mounting sur face .
Note: If you are drilling into fiber glass , use a small drill bit to drill pilot holes before drill-
ing
the screw holes .