User's Manual

22 | Configure displays to use radar
• Select Adjust Radar, then select Installation.
• The Bearing Alignment button shows the current setting. Select it to change the setting.
Use the Up and Down buttons to move the radar image one degree at a time, until the
radar overlay is aligned with the chart.
• Select OK.
• Select Return.
Simrad NX40/45 or Northstar M84/M121 radar setup
When the radar is enabled, it will turn on, warm up, and enter standby mode.
To enable the radar functionality:
• Press Setup (NX) or menu twice to display the Setup menu, then select system
• Set Radar to
.
Zero bearing
Adjust this on a chart window with the radar overlay on.
• Press Menu twice > Radar > Installation
• Select Zero bearing then use the arrow keys to enter the new bearing angle.
Antenna height
• Press Menu twice > Radar > Installation
• Select Antenna height then enter the height of the antenna above sea level.
Preliminary