User's Manual

10 | Install the radar
Mounting the scanner
• Use the supplied mounting template and tape it securely to the chosen location site.
• Before drilling, check that:
-
you have oriented the mounting template correctly so that the front of the scanner
unit will face the front of the vessel
-
the location site is not more than 15 mm (0.6") thick. If the location site is thicker use
longer bolts
Note: The bolts supplied are M8 x 30 mm x 4. If you need to use longer bolts make sure they
are 304 stainless steel and allow for 15 mm (0.6") of thread contact
• the location site allows the drain hole to empty.
• Drill the four holes where shown.
• Remove the mounting template,
• Connect the scanner interconnection
cable (see "Connect the Broadband radar to your
display" page 16)
• Position the scanner carefully over the bolt holes so that they are aligned
• Place a spring washer then a plain washer onto each bolt, as shown.
• Screw each bolt into each drill hole from the under side of the location site, and tighten
securely
Preliminary