Installation Manual

www.NavePoint.com 7 [e-mail]
8U Configuration
Warning: Do not attempt to mount to wall, when equipment is mounted inside rack. Rack can hold up
to 150 pounds evenly distributed. Make sure wall surface can hold weight of rack/equipment.
Insert one end of the Short
Vertical Mounting Rails (B)
into the corner of the
Bottom Panel Frame (A)
(both panel frames can be
used as a top or a bottom)
and secure them with 2 of
the M5 x 10 mm Hex Head
Screws (G) on each side
using Hex Wrench (J).
Note: The front of the
Bottom Mounting Panel
Frame (A) has a front panel
without wall-mounting
holes
Insert and connect the Top
Panel Frame (A) onto the
Short Vertical Mounting
Rails (B) with 2 of the M5 x
10 mm Hex Head Screws
(G) on each side using Hex
Wrench (J).