Installation Manual
www.NavePoint.com 5 customerservice@navepoint.com
-Mounting Rails
The enclosure comes with reversible horizontal mounting
rails that have threaded holes for mounting rack
equipment. The holes on one side of the rail are threaded
for M6 hardware, while the holes on the other side are
threaded for 12-24. Orient the rails so the hole type you
need is on top. To install equipment, use the included M6
or 12-24 hardware to secure equipment to the rails. (See
the following page for equipment installation
instructions.)
Warning: Be sure to have the enclosure securely
mounted to the wall, or in its final position on the floor
before mounting any equipment inside. Additionally, be
sure to make all necessary adjustments to the rails before
mounting equipment. (See below for Adjusting Mounting
Rail Depth.)
-Adjusting Mounting Rail Depth
Do not adjust the mounting rails unless your equipment requires
a different mounting depth.
The rails can be adjusted in 1-inch increments for mounting
depths.
Model
Mounting Depth (Adjustable)
2U
17’’ to 20’’ (432 to 508mm)
2U36
33’’ to 36’’ (838 to 914 mm)
5U
17’’ to 20’’ (432 to 508mm)
5U36
33’’ to 36’’ (838 to 914 mm)