Installation Manual

www.NavePoint.com 4 [e-mail]
2. Rack Assembly
A
Top Section of Rack x2
Bottom Section of Rack x2
Assemble a top section by sliding two top corner sections
(F) over the ends of a top center section (G). Align the
pieces so the numbers printed on the center section
show through the cutouts in the two top corner sections.
The numbers determine the rack’s mounting depth. Use
the Rack Depth Table (provided above) to assist with
determining rack depth. When the sections are aligned
at the required depth, secure each section in place with
an M8 x 16mm Hex Bolts (I) using M8 Wrench (M). Bolts
should be fixed in place, but not completely tightened.
Repeat the process to assemble the other top section.
Make sure the depths match the other top section.
Assemble a bottom section by sliding two bottom corner
sections (D) inside the ends of a bottom center section (E) .
Align the sections so the numbers match the numbers you
used for the top sections. When the sections are aligned at
the required depth, secure each section in place with two
M8 x 16mm Hex Bolts (I) using M8 Wrench (M). Bolts should
be fixed in place, but not completely tightened.
Repeat the process to assemble the other bottom section.
Make sure the depths match the other bottom section.