Installation Manual
www.NavePoint.com 7 customerservice@navepoint.com
-Adjusting Mounting Rail Depth
1.Each vertical Mounting Rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper corner
and another in the lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the
enclosure.
2.Move the cage nuts to the desired depth and reinstall.
3. Slide the mounting rails to the desired depth and reattach them.
4. Equipment Installation
1 Rack Unit
Note: The unit comes with two different kinds of screws for equipment installation, black and silver. Use the
black mounting screws if you are securing your equipment to the square hole side of the mounting rail. Use
the silver screws if you are securing your equipment to the tapped hole side of the mounting rail.