Installation Manual
www.NavePoint.com 5 customerservice@navepoint.com
2: There are 4 levelers included with your rack enclosure, 2
for the front and 2 for the rear. Using a 14 mm open-end
wrench, install the levelers at the base of the unit using the
threaded holes near each corner of the enclosure by turning
the leveler counter-clockwise.
3: Use the 19 mm open-end wrench to lower each leveler
until it contacts the floor.
3. Enclosure Configuration
-Door Locks
The front/back door and both side panels contain locks that
are lockable with the included keys.