Installation Manual
www.NavePoint.com 5 customerservice@navepoint.com
- Mounting Rails
The enclosure comes with mounting rails that have both square and tapped holes for mounting rack equipment.
1.Each rail is connected to the enclosure with 2 screws and 2 cage nuts: 1 set in the upper corner and another in the
lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the enclosure.
2.Move cage nuts to the desired depth and reinstall.
3. Slide the mounting rails to the desired depth and reattach them.
Squared Hole Mounting Rail
Alternate Mounting: Tapped Hole Mounting Rail
Switch the rail locations. Ensure the tapped hole side of each rail is facing the front door.
Reattach the mounting rails.