Installation Manual

www.NavePoint.com 4 [e-mail]
Use a 17mm Wrench (not
included) to attach the
Equipment Mounting Frame
to the other “A” Wall Mount
Frame, using the other T
bolt, washer, pivot bearing,
and locknut as shown in the
diagram.
Note: Additional washers
have been included that can
be used in conjunction with
the pivot bearing to provide
additional spacing if
necessary.
The Equipment Mounting
Frame should be tightened
to the 2 “A” Wall Mount
Frames enough to provide a
stable attachment while also
allowing for an easy
swinging arc. This may take a
few adjustments that are
recommended to be made
before installing equipment
into the rack.
Insert the two locking pins
to stabilize the rack. You do
not want the rack to swing
at all while installing
equipment.