Owner's Manual

NS14A/NS27A/NS35A INSTALLATION

Connection Descriptions

NOTE:

Be sure to follow specific instructions included with your product. The informa-

tion below should be used as a general guide only.

RED Power wire (12V+)

• Disconnect negative battery terminal before proceeding. Consult a qualified

technician for instructions if you are unsure.

• Plan wire routing before cutting any wires to length. Use a grommet when

running wires through the firewall or metal openings.

• Use extreme caution when drilling holes to avoid damaging fuel lines or

existing vehicle wiring.

• The +12V wire must be fused within 18” from the battery for protection of the

vehicle’s electrical system.

BLACK Ground wire (GND)

• Choose a clean unpainted section of metal or the vehicle chassis when

attaching the ground wire. Be sure to clean the area of any dirt or grease.

UNIVERSAL DIN CABLE (INCLUDED)

• BLUE LED wire (12V+) - Turns LED ON/OFF

• WHITE/RED RCA - Left/Right audio inputs

• GREY RCA - DIGITAL COAXIAL HI-DEF INPUT (DO NOT CONNECT TO ANALOG

AUDIO SOURCE)

*DIGITAL OUT NOT USED

UNIVERSAL CABLE

Digital

8 pin waterproof DIN connector

LED ON/OFF

NOTE: Some 3rd Party Radios/Source

Units might have a preout of 1V or

less, this will cause the audio output

to sound to sound low. We recommend

that a RCA line driver be used in this

situation to increase the preout voltage

and raise the sound level of the amplifer.