Owner's Manual

NS14A/NS27A/NS35A INSTALLATION

Preparation/Installation

Please read entire manual before installation.

Before You Start

• Disconnect negative battery terminal. Consult a qualified technician for

instructions.

• Use extreme caution when drilling holes to avoid damaging fuel lines,

hydraulic lines or existing wiring.

• If additional wiring is required, we recommend that you run all wires prior to

mounting your speaker in place.

• Use the highest quality connectors for a reliable installation and to minimize

signal and power loss.

• Avoid running wires over, near, or through sharp edged surfaces. We suggest

you also use rubber grommets to protect any wires routed through metal.

Mounting and Installation

• Determine where the sound bar will be mounted. Ensure an area large enough

for the sound bar to mount evenly.

Part List

8x 5mm x 12mm Allen screws (Flush Mount Anchors) 2X Adjustable Brackets

8x 5mm x 15mm Allen screws (Adjustable Brackets) 2X Adjustable Anchors

2x 5mm x 15mm Allen screws (Adjustable Anchors) 2X 1.5” Bar Clamps

2x 2mm Allen screws (Adjustable Anchor Lock) 2X 1.75” Bar Clamps

2X Flush Mount Clamps 2X 2” Bar Clamps

4X Flush Mount Anchors 1 X Fuse Holder

Gaskets(Bar Mount & Flush Mount) 1 X Allen Tool

CLAMP GASKET *4

1.5’ BOTTOM

GASKETS *4

1.5’ TOP

GASKETS *2

1.75’

TOP

GASKETS *2

2’ TOP

GASKETS *2

1.75’ BOTTOM

GASKETS *4

2’ BOTTOM

GASKETS *4