NA30C INSTALLATION/OWNER'S MANUAL AM/FM/WB receiver with Bluetooth IP66
NA30C Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions. • Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration. Getting Started • Remove trim ring from unit. • Remove 2 transit screws located on top of the unit.
NA30C Wiring Diagram BROWN/WHITE----FRONT LEFT CH BROWN/RED----FRONT RIGHT CH BLACK----POWER CABLE GRAY/WHITE----REAR LEFT CH GND(-) ACC (+) GRAY/RED----REAR RIGHT CH REVERSE (+) REMOTE (+) BLACK /RED----USB CHARGE (ONLY) BLACK/GREEN----SUB LEFT BLACK----USB PLAYBACK (ONLY) BLACK/GREEN----SUB RIGHT GRAY/VIOLET----CAMERA IN * BLACK----DIGITAL OUT ** GRAY/RED----AUX IN BLACK----ANTENNA INPUT(AM/FM ) * Rear view camera is sold separately.
NA30C Control Locations - Receiver 1. Power/Mute 2. Audio/Menu 3. Tune/Track Down 4. Tune/Track Up 5. Mode/Camera (Hold 5 seconds) 6. Select/Preset Menu 7. Preset Up 8.
NA30C General Operation Power On/Off Mode Auxiliary Input Volume Mute Set the Clock 12/24-hour Clock Camera Press off. to turn the unit on. Press and hold to turn the unit Press MODE to enter the Mode Menu, then press MODE or rotate the volume knob to select between Radio, Auxiliary Input, USB and Bluetooth modes. Modes of operation are shown in the display. The NA30C uses a 3.5mm connection to any external or portable device for audio streaming.
NA30C Setup Menu Press MENU to toggle through and select one of the following setup menus: Audio, General, Screen and Bluetooth. 1. Once the desired menu is displayed, rotate the volume knob to scroll through the list of menu options. 2. Press SELECT to select a specific option to adjust, then rotate the volume knob left/ right to adjust or activate the desired feature. 3. Press SELECT to confirm and save the changes.
NA30C AM/FM Tuner Operation nn ll nn ll Manual Tuning or TUNE momentarily to change radio frePress TUNE quency up or down one step at a time. Press and hold to advance quickly. Seek Tuning Press TUNE or TUNE for more than two seconds (then release) to automatically seek and tune to the next strong station. Band Press BAND to select between FM1, FM2, FM3, AM1, AM2 and WB (weather band) bands.
NA30C USB Operation Playing MP3/WMA Files To play MP3 files, connect a USB device containing MP3/files. “USB Loading" will flash in the display. Depending on the number of files and folders, this may take several seconds. Play/Pause Press the BAND button to pause or resume playback. Next Track ll to advance to the next track. Press TUNE nn to return to the beginning of the current track, and press TUNE nn again to return to the previous track.
NA30C MP3/WMA Operation File/Folder Compatibility and Support Type Specification • MP3 data (.mp3) Compatible File Types • WMA data (.
NA30C Bluetooth Operation Preparation Pairing a New Device Before you can use a Bluetooth device, it must be paired and connected. Make sure that Bluetooth is activated on your device before you begin the pairing process. The NA30C broadcasts the pairing signal constantly when no devices are currently connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
NA30C Notes 11
NA30C Limited One-Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from sta te to state What to do? 1. Before you call for service, check the troubleshooting guide in your owner’s manual. A slight adjustment of any controls may save you a service call. NavAtlas warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. 2.
NA30C Troubleshooting Problem Unit will not turn on (no power) Unit blows fuses NO FILE appears on display NO SUPPORT appears on display Cause Action Yellow wire not connected or incorrect voltage Red wire not connected or incorrect voltage Black wire not connected Fuse blown Yellow or red wire touching chassis ground Speaker wires touching chassis ground Incorrect fuse rating Check connections for proper voltage (11-16VDC) WMA file is protected by DRM (Digital Rights Management) Use WMA files tha
NA30C Specifications FM Tuner Tuning range: 87.5MHz-107.9MHz Usable sensitivity: 8.5dBf 50dB quieting sensitivity: 10dBf Stereo separation @ 1kHz: >30dB Frequency response: 30Hz-13kHz AM Tuner Tuning range: 530kHz-1710kHz Usable sensitivity: 22uV Frequency response: 30Hz-2.2kHz General Preout Voltage: 4.5 Volts RMS Dimensions: 4 1/16" x 2 13/16" x 3 1/2" (104x73x98mm) Design and specifications subject to change without notice.
NA30C FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Support Line: 1-562-946-7471 Monday-Friday, 9AM-5PM PST www.navatlas.com All rights reserved.
Bracket Installation Head Unit NA30C Bracket ------Screw-- ~ ~ () cJ cJ () () (} () ~ .,.
NA30C QUICK START GUIDE 3" Water-Proof Media Center with AM/FM/WB Built-in Bluetooth, IPX6 This Quick Start Guide gives you the basics to start using your NA30C. Please visit www.navatlas.com to download a complete owner's manual or call customer service at 1-562-946-7471 (Monday-Friday,9AM-5PM PST).
Installation ---~~ J' Btad
Control Locations ® ~~ 1. Power/Mute 2. Audio/Menu 3. Track/Tune down 4. Track/Tune up 5. 6. 7. 8. Mode/Camera Select/Preset Menu Preset Up Play/Pause/Band Main Menu Press the Mode button to select from the corresponding modes: USB, Radio, Aux,Bluetooth.
Audio Menu Press the Audio/Menu button to enter into the system menus. *Use the volume knob to scroll/adjust and the select button to choose. * 12: 32 PM System Menu Press the Audio/Menu button to enter into the system menus. *Use the volume knob to scroll/adjust and the select button to choose.
USB Operation To play audio files or MP3 files from a USB device, insert the device and playback will begin automatically. To return USB playback from another mode of operation, select the corresponding icon from the Main Menu. Radio Operation Press Mode button to select Radio from Main Menu screen. Press Select while in Radio mode to enter the Preset Menu.
Aux Operation Press Mode button to select Aux from Main Menu screen.
Bluetooth Operation Press Mode button to select Aux from Main Menu screen. Bluetooth source is for music streaming only. Pairing and Connecting Before using Bluetooth functions, you must pair your mobile phone to the NA30C unit. The device name is "NA30C". To ensure the best reception for pairing and re-connection, please make sure the mobile phone battery is fully charged before you begin. • Try to perform pairing within a few minutes of the mobile phone being turned on.
One-Year Limited Warranty One-Year Limited Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. NavAtlas warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase.
One-Year Limi~ed Warranty Exclusion of Certain Damages: This warranty is exclusive and I lieu of any all other warranties, expressed or implied, including without limitation the implied warranties of merchantability and fitness for a particular purpose and any obligation, liability, right, claim or remedy in contract or tort, whether or not arising from the company's negligence, actual or imputed.
FCC Compliance This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, (2) This device must accept any interference received , including interference that may cause undesired operation. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
