Owner's Manual

INSTALLATION
Connection
Descriptions
NOTE:
Be
sure to follow specific instructions included with your amplifier installation kit
(not included with this amplifier). The information below should be used as a general
guideline only.
Power Wire
(+
12V)
•
Disconnect negative battery terminal before proceeding. Consult a qualified
technician for instructions if you are unsure.
•
Plan wire routing before cutting any wires to
Length.
Begin
by
routing the power
+
12V
wire from the battery to the amplifier
Location.
Use
a grommet when running
wires through the firewall
or
metal openings. Avoid running the .power wire near
existing vehicle wiring to prevent induced noise from entering the audio system.
•
Use
extreme caution when drilling holes to avoid damaging fuel
Lines
or
existing
wiring.
•
The
+
12V
wire
MUST
be
fused within
18"
of the battery for protection of the vehicle's
electrical system.
Ground Wire
(GND)
•
The amplifier ground wire should
be
as short as possible
(no
more than
36"
or
1 meter).
Choose
a clean unpainted section of metal
or
the vehicle chassis when
attaching the ground connection.
Be
sure
to
clean the area of any dirt
or
grease.
Remote Tum-on Wire
(REM)
•
The remote turn-on
wire connects to the head unit's amplifier turn-on lead
or
power antenna output.
Speaker Wires
• Choose adequate gauge speaker wire depending
on
your exact amplifier/speaker
combination.
Be
sure
to
observe polarity when connecting.
•
Do
not ground any speaker wires
or
connect any speaker wires together.
Input
Signal
•
The amplifier's input signal connects to the head unit's low level
(RCA)
outputs.
CAUTION
•
Keep low level inputs away from any power wires to avoid engine noise.
•
Never run any wires underneath
or
outside the vehicle
3