Owner's Manual

INSTALLATION
FCC
Compliance
This device complies with Part
15
of the
FCC
Rules. Operation is subject
to
the following two conditions:
(1)
this device may not cause
harmful
interference. and
(2)
this device must accept any interference received. including
interference that may cause undesired operation.
Warning: Changes
or
modifications
to
this unit not expressly approved
by the party responsible for compliance could void the user's authority
to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for
a Class 8 digital device. pursuant
to
Part
15
of the
FCC
Rules. These
limits
are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates. uses
and can radiate radio frequency energy and.
if
not installed and used in
accordance with the instructions. may cause
harmful
interference
to
radio
communications. However. there is
no
guarantee that interference
will
not occur in a particular installation.
If this equipment does cause harmful
interference
to radio
or
television reception. which
can
be
determined
by
turning the equipment off and
on.
the user is encouraged
to
try
to
correct
the interference by one
or
more of the following measures:
•
Reorient
or
relocate the receiving antenna.
• Increase
the separation between the equipment and receiver.
•
Connect the equipment into
an
outlet
on
a circuit different from that
to
which the receiver is connected.
• Consult the dealer
or
an
experienced radio/TV technician for help.
• Only
shielded interface cable should
be
used.
Finally. any changes
or
modifications
to
the equipment by the user not
expressly approved
by
the grantee
or
manufacturer could void the users
authority to operate such equipment.
13