Operation Manual

17
Action Button(s) Description
mode only) zoom level to a fix, predefined value.
Smart Zoom is disabled. These buttons
are available in 2D mode.
Tap&hold any of the buttons
to set its
value to the current zoom level, or to reset
it to its original value.
Tilt and zoom preset
buttons (available in
Advanced mode only)
Tap one of the preset buttons
to set the tilt
and zoom levels to fix, predefined values.
Smart Zoom is disabled. These buttons
are available in 3D mode.
Tap&hold any of the buttons
to set its
value to the current tilt and zoom levels, or
to reset it to its original value.
Map scale
IGO 8 shows the scale of the map in 2D
mode.
Fit-to-screen
This button does not appear on the Map
screen. It is available on the following
screens:
• Plan on Map screen: When you
have an active route, you can
display it in its full length on the
map.
• Track Information screen: A track
log can be displayed in its full
length on the map.
2.3.3 Lane information and Signposts
When navigating on multilane roads, it is important to take the appropriate lane in order to follow the
recommended route. If lane information is available in the map data, IGO 8 displays the lanes and
their directions using small arrows either at the bottom or at the top of the map (the position of these
arrows can be modified in Map Screen settings). Arrows in yellow represent the lanes you need to
take.
Where there is additional information available, signposts substitute arrows. Signposts are always
displayed at the top of the map. The colour and style of the signposts are similar to the real ones you
can see above road or by the roadside. They show the available destinations and the number of the
road the lane leads to.
All signposts look similar when cruising (when there is no recommended route). When navigating a
route, only that signpost is displayed in vivid colours that points to the lane(s) to be taken; all others
are darkened out.