Installation Guide

BEFORE YOU BEGIN:

 Verify location of underground utilities before you dig!

 Locate property lines.

 Review local and regional building codes, regulations and zoning laws

which may affect your fence.

 Obtain all necessary permits as required by local building codes

Santa Fe & Mesa Gate Installation Instructions

Tape Measure

Drill

3/8” Hex Nut Driver

9/16” End Wrench

Ø1/4” Drill Bit

Philips Head Driver

The 48” Santa Fe and Mesa Gate Kit Assembly comes partially assembled requiring minimal steps to

install your gate to complete your fence. Please read and follow these instruction to obtain a profes-

sional gate installation. This gate is designed to fit within a gate opening of 48 inches.

The first step to install the Santa Fe and

Mesa Gate is to establish the orientation of

the gate. You will need to decide:

 Which side of the gate the hinges will

be placed

 The direction of the swing of the gate

 The side of the gate you want to face

which direction.

48”

GATE POST

TOOLS REQUIRED:

PAGE 1
Santa Fe & Mesa Gate Installation Instructions BEFORE YOU BEGIN: TOOLS REQUIRED: Verify location of underground utilities before you dig!  Locate property lines.  Review local and regional building codes, regulations and zoning laws which may affect your fence.
PAGE 2
Next attach the upper and lower hinges to the gate by:  First laying the gate on a non-scratch surface with the in-swing side of the gate facing up  Position the hinges on the gate hinge side vertical beam as shown and attach each hinge using 4 self-drill screws. 2” Hinges 2” Gate Flush with top of Gate Post Next attach the gate to gate post by:  Positioning the gate assembly in gate opening in the orientation you selected earlier.
PAGE 3
Once the gate hinges are attached remove the shim blocks from under the gate. The gate should now swing freely on the gate post. The gate should fully swing into the gate opening and the gaps between the posts and the gate should be even. If the gate hits the posts when it swings in or the gaps are uneven adjust the spacing with the two nuts on the hinges using a 9/16” end wrench. Once the gate is properly positioned secure the gate in position by tightening the 2 nuts on each hinge.