Installation Guide

Install the Latch Assembly by:
 Attach the post side of the latch as-
sembly using 2 self drilling screw ap-
proximately 42” above the ground.
 Drill a ø1/4” hole in the upper hole lo-
cation through the post.
 Insert the plastic bushing
 Secure latch handle using the supplied
philips head screw.
Once the gate hinges are attached remove the shim
blocks from under the gate. The gate should now
swing freely on the gate post. The gate should fully
swing into the gate opening and the gaps between the
posts and the gate should be even. If the gate hits the
posts when it swings in or the gaps are uneven adjust
the spacing with the two nuts on the hinges using a
9/16” end wrench. Once the gate is properly positioned
secure the gate in position by tightening the 2 nuts on
each hinge.
Complete the installation by attaching the latch
catch as shown.
 With gate in the closed position, attach the
catch side of the latch with self-drilling screws
so the latch assembly properly latches and
releases
Congratulations! Your have just successfully installed your gate.
Enjoy!
42”
Drill Ø1/4” hole