Installation Guide
4. On Santa Fe Fences, the last fence board may extend above the top of the post, or end too far below the top of the post. If this
happens, simply adjust the Bottom Rail Brackets to achieve the correct alignment before installing the Top Rail.
On Mesa Fences, all the fence boards may extend above the top of the post, or end too far below the top of the post. If this
happens, adjust the Bottom Rail Brackets to achieve the correct alignment before installing the Top Rail.
5. Install the Top Rail between the posts. No fasteners are necessary because the Top
Rail will be secured by the Post and Rail Caps.
1302 Industrial Park Avenue
Torrington, WY 82240
307-532-9942 Tel
307-532-9943 Fax
877-810-4029 Toll Free
www.naturescomposites.com
Natures Composites’ products are manufactured in the U.S.A. and are distributed through retail and wholesale
channels throughout United States, Canada, Mexico, and Europe. Learn more about Natures Composites and our
product lines by visiting www.naturescomposites.com today.
d
GATES:
Santa Fe Gates and Mesa Gates are
available pre-assembled for ease of
installation.
Patent Pending.
d
POST AND RAIL CAP INSTALLATION:
Complete construction of the fence panel by installing the Post and Rail Cap. The
Post and Rail Cap ts over the top of the post and extends over the Top Rail. Postion
the Post and Rail Cap by centering on post so that the cap extends onto the top
rail equally on both sides of the post. Fasten the cap with se-tapping screws by
positioning in the predrilled holes in the Post and Rail Cap and driving the screw into
the Top Rail.
TOO HIGH
TOO LOW
ADJUST RAIL
ANGLE BRACKET
TOP RAIL
POST
POST AND
RAIL CAP
SANTA FE GATE MESA GATE
ADJUSTABLE
GATE HINGE
GATE LATCH