Installation Guide

d INSTALL BOTTOM RAIL BRACKETS
AND BOTTOM RAIL:
Insert Bottom Rail Bracket into the bottom
of each post as shown. Align the Bottom
Rail Bracket so that the top of the bracket
is parallel to and 2" above the ground.
Tighten the bolt and nut using a 9/16"
wrench. Position the Bottom Rail onto the
brackets.
If your installation requires spacing shorter
than 96" (eight feet) you will need to use a
chop saw to cut the Top Rail and Bottom
Rail to t between the posts.
d FENCE BOARD INSTALLATION:
1. Fence boards come pre-cut to the maximum post spacing size.
However, if your installation requires post spacing shorter than 96"
(eight feet) you will need to cut the fence boards to the correct length.
Measure the distance between the insides of the U-Channel of the two
posts you are installing the section of fence boards into. Cut the fence
boards to 1/2" shorter than the distance you just measured in order
to maintain a 1/4" gap between each end of the fence board and the
inside of each post.
2. Install Santa Fe Fence Boards with the tongue of the fence board
facing up and the groove in the fence board facing down. hold the
fence board at an angle and insert one end into the channel of a post.
Then rotate the other end of the fence board down until it slides into
the channel of the other post. Push the rst fence board down until it
comes to rest in the Bottom Rail.
Install Mesa Fence Boards with the groove of the rst board inside the
post, and the tongue facing outwards.
3. Install the remaining fence boards, pressing each groove onto the
previous board's tongue. DO NOT USE A HAMMER TO FORCE
THE FENCE BOARDS INTO POSITION, AS IT MAY DAMAGE THE
COMPOSITE FENCE BOARDS!
Measured
Distance
1/4"
Channel
Nut
Posts
Bottom Rail
Bracket
Bolt
Bottom
Rail
2"
Santa Fe
Fence Boards
Mesa
Fence Boards
UP
Tongue
UP
Tongue
Groove
Post
Groove
INSTALLING
SANTA FE
FENCE BOARDS
INSTALLING
MESA FENCE
BOARDS