SDS

Page 3/7
Safety Data Sheet
acc. to OSHA HCS
Printing date 05/07/2015 Reviewed on 05/07/2015
Trade name: NM S&O REMOVER CA
(Contd. of page 2)
40.0
·
Control parameters
·
Components with limit values that require monitoring at the workplace:
67-63-0 Isopropyl Alcohol
PEL Long-term value: 980 mg/m³, 400 ppm
REL Short-term value: 1225 mg/m³, 500 ppm
Long-term value: 980 mg/m³, 400 ppm
TLV Short-term value: 984 mg/m³, 400 ppm
Long-term value: 492 mg/m³, 200 ppm
BEI
·
Ingredients with biological limit values:
67-63-0 Isopropyl Alcohol
BEI 40 mg/L
Medium: urine
Time: end of shift at end of workweek
Parameter: Acetone (background, nonspecific)
·
Additional information:
The lists that were valid during the creation were used as basis.
·
Exposure controls
·
Personal protective equipment:
·
General protective and hygienic measures:
The usual precautionary measures for handling chemicals should be followed.
·
Breathing equipment:
Not required.
·
Protection of hands:
The glove material has to be impermeable and resistant to the product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/
the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the
degradation
·
Material of gloves
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality
and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the
resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the
application.
·
Penetration time of glove material
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be
observed.
·
Eye protection:
Goggles recommended during refilling.
9 Physical and chemical properties
·
Information on basic physical and chemical properties
·
General Information
·
Appearance:
Form:
Fluid
Color:
According to product specification
·
Odor:
Characteristic
·
Odour threshold:
Not determined.
·
pH-value at 20 °C (68 °F):
7.5
·
Change in condition
Melting point/Melting range:
Undetermined.
Boiling point/Boiling range:
100 °C (212 °F)
·
Flash point:
Not applicable.
(Contd. on page 4)
USA