Product Manual

Page 13
disconnected unless the AC plug on the unit is removed and the „Power‟ button is held for a
second to turn unit off.
Using the USB port
The USB port on the system provides standard 5V 750mA power to power up USB powered
handheld device.
AC Load on Solar Home and RV Kit System
Although the unit can provide high surge power up to two times the rated output power, some
appliances may still trigger the unit‟s protection system. A higher power system like Solar Home
and RV Kit 1800W is required for those appliances.
Some appliances like speed controllers found in some fans and AC chargers for some power tools
may not like the modified sine wave generated by the inverter. Those appliances may not work or
may be damaged if they are connected to the inverter. If you are unsure about powering any
device with the inverter, contact the manufacturer of the appliances.
Unit Mode Setting
U
n
d
e
r
s
t
a
n
d
i
n
g
t
h
e
E
r
r
o
r
C
o
des
Error
Code
Condition
Corrective Action
E01
System senses battery voltage is low
and has shutdown.
Recharge battery immediately and restart
unit.
Mode
Status
indicator
Display
Condition
Full
Automatic
In1, Al1
(factory
default
setting)
Solid
green
“Ful”
AC output is supplied by utility power. Internal
battery is fully charged.
Flashing
green
Battery
capacity in %
AC output is supplied by utility power. Charging
of internal battery by the 2A charger is in
progress.
Solid
amber
Flash between
Output Power
in kW & battery
capacity in %
AC output power is generated by the inverter
using the internal battery and/or from the
optional NATURE POWER solar panel.
Flashing
amber
Same as
above
Same as above and utility AC power is just
detected and AC output will switch to utility
power within seconds.
Solid red
“E01-E10”
Error on unit is detected. AC output is
disconnected. See Trouble shooting section.
Full
Automatic
Silent
In1,Al0
Same as “Full Automatic” mode but with audio alarm mute if error occurs. The
unit fault protection features remain active.
Backup
Disable
In0,Ch1,Al1
Solid
green
“Ful”
AC output is supplied by utility power. Internal
battery is fully charged.
Flashing
green
Battery
capacity in %
AC output is supplied by utility power. Charging
of internal battery by 2A charger is in progress.
Backup
Disable
with Alarm
Disable
In0,Ch1,Al0
Same as “Backup Disabled” mode but with audio alarm mute. The unit fault
protection features remain active.