Use and Care Manual

7) Rinse
Submersible Filter Pump Motor Pump
Replace Recommended Pump Motor Type: Rule Marine by Xylem (Only)
Rule Marine Model Size: Look and see for your particular model size in GPH
New Pump Installation Directions:
1)
Pull the Savior out of the water and flip it upside down
2)
Unclip the old pump and pull the cord out until it stops (about a foot long of cord or so)
3)
Then cut the cord (two wires) leaving length/room to work and wiring together. Note: If you
need to unscrew the Solar Panel from the Savior float to have the wire length /room, please
do so.
4)
Then wire the new pump up with the two wires by splicing the two wires together and black
tape well.
Note: black/-/black ground wire and Brown/+/Red wire connection - Solar Panel Jbox is also
marked + and – if you unscrew the Solar Panel.
5)
Then push the new connected wires back in the Savior float wiring hole.
6)
Then clip the new pump back on the blue clamps - with the pumps water return facing up or
so you know the water flow is going down to the bottom of the pool.
7) Let the sun fully hit the solar panel, turning the new installed pump ON... place back in the
water.
NATURAL CURRENT | PO Box 3803, Dana Point, CA 92629 | Phone: [phone]
E-Mail: [e-mail] | Web Site: http://www.naturalcurrent.com