Installation Sheet
INSTALLATION INSTRUCTIONS
PUSH TO SEAL BATH WASTE & OVERFLOW DR290
DRAIN
1. Separate all mounting hardware as shown.
2. Apply 100% silicone (non-water based) to
underside of Flange (A) and then place directly
into drain opening of the bathtub.
3. From underneath the bathtub slide the Rubber
Gasket (B), the Retaining Washer (C), and the
Lock Nut (D) onto the threaded seat of Flange (A)
and tighten into position.
OVERFLOW
1. Cut Overow Tube (A) to the appropriate length.*
2. Position Decorative Shroud (B) on the Overow
Tube (A) so that it will be above the opening in
the suboor when installed.
3. Insert the 2" Screw (F) through the Overow Cover
(E). For thick walled tubs thread the Screw Extender
(D) onto the 2" Screw (F), creating the Cover Assem-
bly (G). For thin walled tubs proceed to step 4.
4. Put Rubber Gasket (C) onto Overow Tube (A) and
align (from the outside) with the overow hole of
the tub, hold in place.
5. From the inside of the tub insert Cover Assembly
(G) into the mounting hole on the Overow Tube
(A). Carefully tighten the Screw (F), making sure
the Overow Cover (E) is in the proper orientation
(opening toward the bottom).
* We strongly recommend that the tub waste and overow be installed
by a professional installer. These instructions do not detail the necessary
connections needed to connect the overow tub and bathtub waste.
Those connections will need to be made by the installer.
Rubber Gasket (B)
Retaining Washer (C)
Lock Nut (D)
OVERFLOW
Rubber Gasket (C)
Overow Cover (E)
Cover Assembly (G)
Screw (F)
**Screw Extender (D)
SIDE VIEW
Flange (A)
Overow Tube (A)
Decorative Shroud (B)
DRAIN
** Screw Extender (D) is used for Avalon or double walled tubs only.