Installation Sheet

INSTALLATION INSTRUCTIONS

1.5” Tear Drop Drain, DR150

1. Separate all mounting

hardware as shown.

4. Wrap the threads on

the Tailpipe (6) with

Teflon Tape.

5. Install Tailpipe (6) into the

bottom of Flange (1)

Remove all excess silicon e around the drain after the drain has been installed

WWW.NATIVETRAILSHOME.COM

SINK

Apply 100% Silicone

(non-water based) to underside

of Flange (1) or use Rubber

Washer (2) (recommended if

installing glass sink) in place of

silicone. Place the Flange (1)

directly into drain opening

of the sink.

From underneath the sink

slide the Rubber Gasket (3),

the Retaining Washer (4),

and the Lock Nut (5) onto

the Flange (1) and tighten

into position, do not

overtighten.

PAGE 1
INSTALLATION INSTRUCTIONS 1.5” Tear Drop Drain, DR150 1. Separate all mounting hardware as shown. 1 2 SINK 3 4 5 6 2. Apply 100% Silicone (non-water based) to underside of Flange (1) or use Rubber Washer (2) (recommended if installing glass sink) in place of silicone. Place the Flange (1) directly into drain opening of the sink. 3. From underneath the sink slide the Rubber Gasket (3), the Retaining Washer (4), and the Lock Nut (5) onto the Flange (1) and tighten into position, do not overtighten. 4.