Installation Sheet

ManualsBrandsNative Trails ManualsBathroom AccessoriesNative Trails 1-1/2" Push to Seal Drain Assembly - Includes Pop-Up

1

2

3

6

4

7

8

1. Separate all mounting

hardware as shown.

2. Either apply 100% Silicone

(non-water based) to underside

of flange (1) OR place rubber

seat washer (2) directly under

the flange and then place

directly into drain opening

of the sink

3. From underneath the

sink slide the Rubber

Gaskets (3,4 & 5), the

Retaining Washer (6), and

the Lock Nut (7) onto the

Threaded Seat (1) and

tighten into position.

4. Wrap the threads on

the Tailpipe (8) with

Teflon Tape.

5. Screw Tailpipe (8) into the

bottom of Threaded Seat (1)

W W W . N A TIV E T R A I L S . N E T

Remove all excess silicone around the drain after the drain has been installed

INSTALLATION INSTRUCTIONS

1.5" Push to Seal Drain, DR130

5

Summary of content (1 pages)