User Manual

Applying FILTER on Stem Parts
To apply the FILTER on Stem Parts:
►
Rotate the Filter knobs to apply the hi-pass or low-pass Filter to the Stem Channels.
→
You will hear the applied Filter on the Stem Channels output.
The usage of the Filter FX in combination with TRAKTOR’s EQ let you mix more precisely and
with more flexibility.
3.8.3 Applying FX SEND to Stem Channels
You can apply the FX of FX Unit 2 to any of the Stem Channels.
Preparation
1. Route FX Unit 2 to the Stem Deck.
2. Enable FX Unit 2 in the TRAKTOR software.
Applying FX SEND
On the F1 controller:
1. Hold the SHIFT button. The four Pads with the FX parameter light up.
2. Now press one of these Pads. You now hear the FX of FX Unit 2 applied to the Stem
Channel.
3.9 Using Step Sequencer Mode
In Step Sequencer mode you can utilize the Remix Decks to program a pattern to be played by
the focused sample on any Remix Slot. For each pattern you can define an individual number
of steps, within a range of 1-16 steps. The default number of steps is 8 steps. The Step Se-
quencer is meant to be used with one-shot samples, e.g. drum sounds such as kick drum,
snare, or hi-hat, or with other short samples like sound effects. While you can also trigger
loops, this may not return the desired results, as the loop will not be played in its entirety.
Tutorials and Workflows
Using F1 for Stem Deck Control
TRAKTOR KONTROL F1 - Manual - 58