User Manual

2. Press the Deck's LOOP button to enable LOOP mode.
The LOOP button lights up brightly and the pads also illuminate.
3. Press pad 6 to jump back by 1 beat. If doing so causes the Playhead to cross the bounda-
ries of an active Loop area, it continues to loop again.
4. Press pad 7 to jump forward by 1 beat. If jumped out of a loop, playback continues as
normal.
Beatjump sizes can be changed in TRAKTOR's software preferences: Preferences>TRAK-
TOR KONTROL S8>Loop Mode Sizes>Beatjump.
Using the Loop encoder to define Beatjump sizes in real time
By default, pad 5 and pad 8 skip position back and forward by the amount shown in the dis-
play as loop-size value. To change this value:
1. Turn the Loop encoder to define a Beatjump size between 1/32 of a beat and 32 beats.
The Loop size will change in the display.
2. Press pad 5 to jump the playback position backward by the loop-size value displayed on
the display. If doing so causes the Playhead to jump into an active Loop area, it continues
to loop again.
3. Press pad 8 to jump the playback position forward by the beat-jump size defined in the
display. If you jump out of a loop this way, playback continues outside the loop.
3.4 Using FREEZE Mode
FREEZE mode takes the playhead position, adds the number of bars set as Freeze Slice Size
and splits this section of a track into eight equally sized slices. These are then mapped to the
adjacent pads, which light up blue. Press any of these pads to trigger playback from the map-
ped slice. Playback continues to the end of the track until you lift your finger off the pad.
In FREEZE mode, the numbers 1 - 8 are overlaid on the waveform to indicate the location of
the slices. The first row of pads triggers slices 1 - 4, the second row triggers slices 5 - 8
Using Your S8—Getting Advanced
Using FREEZE Mode
TRAKTOR KONTROL S8 - Manual - 97