User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL S8!
- Using Your S8—Getting Started
- Using Your S8—Getting Advanced
- Hardware Reference
- Common Setups
- Preferences Pane in TRAKTOR
- The S8 Audio Interface and Control Panel
- Troubleshooting - Getting Help
- Technical Specification
Pads illuminated in LOOP mode.
Prerequisites
We assume here that the S8 is in the following state:
• The track “Techno 1” is loaded on Deck A and is not playing.
• The Crossfader is all the way to the left.
• The channel fader A is raised to the top.
• The MAIN knob has an adequate level.
3.3.1 Looping with Pre-defined Sizes
In LOOP mode, with the first row of pads you can engage loops with pre-defined values. By
default, these are (from left to right) 1/8, 1/4, 1/2 or 1 beat.
To engage a loop:
1. Press the Deck's PLAY button to start playback.
2. Press the Deck's LOOP button to enable LOOP mode.
The LOOP button lights up brightly and the pads also illuminate.
Using Your S8—Getting Advanced
Playing with Loops in LOOP Mode
TRAKTOR KONTROL S8 - Manual - 95