User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL S8!
- Using Your S8—Getting Started
- Using Your S8—Getting Advanced
- Hardware Reference
- Common Setups
- Preferences Pane in TRAKTOR
- The S8 Audio Interface and Control Panel
- Troubleshooting - Getting Help
- Technical Specification
Number Description Links leading to section with further information
(4) Input level meter ↑4.4.1.6, Channel Meter
(5) EQ (HI, MID, LOW) knobs ↑4.4.1.4, EQ Knobs
(6) FILTER button and FILTER knob ↑4.4.1.7, FILTER Button and FILTER Knob
(7) CUE button ↑4.4.1.8, CUE Button
(8) Channel fader ↑4.4.1.5, Channel Fader
4.4.1.1 GAIN Knob
The GAIN knob controls the level a channel receives from the corresponding Deck or audio in-
put.
GAIN Encoder
►
Adjust the levels of tracks you want to mix or cross-fade between by turning the tracks'
GAIN knobs in order to avoid differences in loudness when mixing.
GAIN is applied after the INPUT and conversion to digital. So if you connect a turntable or
any other external device and your channel level meter is constantly moving beyond the
four orange segments with the GAIN knob in center position, dial back that device's output
level until only the loudest passages reach the orange range of the Input level meter.
4.4.1.2 TRAKTOR Button
Use this button bearing the TRAKTOR logo to switch a channel between TRAKTOR and Direct
Thru mode.
TRAKTOR Button
Hardware Reference
The Mixer
TRAKTOR KONTROL S8 - Manual - 205