User Manual
Table Of Contents
- Title Page
- Disclaimer
- Contact
- Table of Contents
- Welcome to the World of TRAKTOR KONTROL S8!
- Using Your S8—Getting Started
- Using Your S8—Getting Advanced
- Hardware Reference
- Common Setups
- Preferences Pane in TRAKTOR
- The S8 Audio Interface and Control Panel
- Troubleshooting - Getting Help
- Technical Specification
4.3.2 FX Unit Assignment
In order to route a Deck's signal to an FX Unit, press the corresponding FX Assign button in the
mixer channel.
FX Assign Buttons
►
In TRAKTOR's default setup with 2 FX Units, press the left FX button to assign the mixer
channel to FX Unit 1. Press the right FX button to assign the channel to FX Unit 2. The
FX assign buttons light up bright orange when assigned.
4.3.3 Additional FX Unit 3 and 4
By default, TRAKTOR is set up with two FX Units. In order to use all four of TRAKTOR'S FX
Units, you need to change the following setting:
►
In TRAKTOR's Preferences, select Effects>FX Unit Routing>4 FX Units.
TRAKTOR's FX Unit Routing Preferences
If you activate 4 FX Units, S8's Performance controls are assigned to FX Units 3 and 4. They
work in a fashion very similar to the dedicated controls in FX Units 1 and 2.
Hardware Reference
The FX Unit
TRAKTOR KONTROL S8 - Manual - 199