User Manual

FX SEND
When FX SEND is selected, the knobs control the amount of signal being sent to the assigned FX
Unit(s), per Slot. The FX SEND amount is displayed right above the corresponding knob.
In case you increase FX SEND and still don't hear any effect, please make sure the Remix
Deck is actually assigned to an FX Unit in the corresponding Mixer channel.
For information on using the Performance Controls to operate FX Units (3 and 4), refer to
section ↑4.3.3, Additional FX Unit 3 and 4.
PITCH
When PITCH is selected, the Performance knobs transpose the pitch of the currently playing
sample. In other words: pitch correction is applied per Remix Cell. The amount of pitch change
is displayed above the corresponding knob.
4.2.9 Slot Volume Faders
S8 offers a separate volume fader per slot. This allows you to mix signals from up to four slots
within a single Remix Deck, before it runs through the channel fader and the Crossfader.
• In case only one Deck per side is a Remix Deck, the faders control that Remix Deck's slot
volume even if another Deck is focused.
• In case both the primary and secondary Deck are configured as Remix Decks, the Slot
Volume faders control the focused Deck's slots.
Slot Volume Faders
Hardware Reference
The Deck
TRAKTOR KONTROL S8 - Manual - 189