User Manual

▪ The value set in the Arrange Grid is used for length increments. For more information on
Arrange Grid, read: ↑14.6, The Arrange Grid.
▪ When [Shift] is pressed while changing the length, the value set in the Step Grid is used.
For more information on Step Grid, read: ↑7.1.7, Adjusting the Step Grid and the Nudge
Grid.
▪ The minimum length a Section marker can be dragged without modifier is one Arrange Grid
increment.
▪ When [Shift] is pressed, the minimum length a Section marker can be dragged is one Step
Grid increment.
▪ The minimum length of a Section equals the minimum Scene length. This can only be ach-
ieved if Arrange Grid or Step Grid is set to Off.
14.3.6.2 Adjusting the Length of a Section Using the Controller
To adjust the length of a Section using your hardware controller:
1. Press SHIFT + SCENE (Section) to enter Arranger view.
2. Press SCENE (Section) to enter Section mode.
3. Select the pad relating to the Scene you want to adjust.
4. Turn Knob 4 to adjust the length of the Section as required. Turning the knob left will
shorten the Section, turning it right will lengthen the Section.
5. Press SHIFT and turn Knob 4 to change the Section length in smaller increments.
→ The Section length is adjusted accordingly.
To adjust the length of a Section using your hardware controller:
1. Press NAVIGATE + Button 3 ARRANGER to access the Arranger view.
2. Press SCENE to enter Section mode.
3. Select the pad relating to the Section you want to adjust.
4. Turn Knob 4 to adjust the length of the Section as required. Turning the knob left will
shorten the Section, turning it right will lengthen the Section.
5. Press SHIFT and turn Knob 4 to change the Section length in smaller increments.
Working with the Arranger
Using Arranger View
MASCHINE - Manual - 777