User Manual

2. If you want to adjust the level of a Sounds, switch to the Sound view by pushing the 4-D

encoder downwards.

3. If you want to adjust the panoramic position of a Sound, press the 4-D encoder and turn

it counterclockwise to pan the Sound to the left or clockwise to pan the Sound to the

right.

4. Use the Page buttons to show the desired channels on the displays. You can also use the

Group buttons and pads of your controller to directly switch to the desired channel.

5. At the bottom of the displays, the selected parameter appears under each channel strip.

6. Turn the desired Knob(s) 1–8 to adjust the displayed parameter in the corresponding

channel(s). You can also use the 4-D encoder to adjust that parameter for the focused

channel.

Hold SHIFT while adjusting a value to make finer adjustments.

In each channel strip the peak value is indicated above the level meter. This peak value is re-

set each time you start the playback via PLAY or RESTART on your controller, or when you

click the corresponding peak value in the software’s Mixer (see section ↑9.2.5, Adjusting Set-

tings in the Channel Strips).