User Manual

Undo/Redo on the Controller
Both Step Undo and Take Undo are also available on your controller:
►
On the MASCHINE hardware controller, perform the Take Undo operation by pressing
SHIFT + pad 1 (UNDO). To perform the Take Redo operation, press SHIFT + pad 2 (RE-
DO).
►
On the MASCHINE hardware controller, perform the Step Undo operation by pressing
SHIFT + pad 3 (STEP UNDO). To perform the Step Redo operation, press SHIFT + pad 4
(STEP REDO).
Take Undo is available in following situations:
▪ Recording in Control mode
▪ Recording in Step mode
▪ Recording modulation
Outside of these three situations, Take Undo has the same effect as Step Undo (see
above).
2.3.4 List Overlay for Selectors
Many MASCHINE parameters are presented in the form of a selector providing a list of possible
values for the parameter (e.g., the Mode parameter of the Saturator Plug-in or the Dest. param-
eter in the Audio page of the Sound’s/Group’s Output Channel settings).
A selector.
From your controller, you can adjust such a parameter by turning the corresponding Knob un-
der the display of your controller.
Basic Concepts
Common Operations
MASCHINE - Manual - 39