User Manual

If the current Loop Range does not start at the beginning of a bar (i.e. on a downbeat), the
count-in phase will start with a downbeat, count the selected duration (1, 2 or 4 bars), and
then add the offset between the beginning of the bar in which the beginning of the Loop
Range is placed and the actual beginning of the Loop Range:
Count-in when the Loop Range starts at the beginning of a bar…
…and when the Loop Range doesn’t start at the beginning of a bar.
You can also use the Count-in to start a recording in Replace mode.
Adjusting the Count-in Duration
You can choose how long the metronome should be heard before the recording actually starts.
In the software this is done via the Count-in Length setting in the General page of the Prefer-
ences panel. Available values are 1 bar, 2 bars, and 4 bars. See section ↑2.6.1, Preferences –
General Page for more details on the Count-in and metronome settings available in the Prefer-
ences panel.
7.2.5 Quantizing while Recording
You can choose to have notes automatically quantized as you record them on the pads. This is
called Input Quantization.
You can also quantize recorded notes at any time. See section ↑7.4.7, Quantizing
Events/Notes for more information.
Working with Patterns
Recording Patterns in Real Time
MASCHINE - Manual - 349