Installation Manual

1. Press BROWSER to open the Browser.
2. Press pad 6 to select its Sound.
3. Press Button 2 above the displays repeatedly until SAMPLES is selected.
4. Check that Button 4 above the displays is not fully lit and that the USER label under-
neath is not highlighted; if necessary, press Button 4 to disable it.
5. Move the 4-D encoder to the left or to the right in order to put the focus (indicated by the
brackets) on All Types, then turn the encoder to select the Drums type, thereby limiting
the results to the drum Samples:
You can also press and hold the 4-D encoder to temporarily display all available types; you
can even turn the encoder while pressing it to see where your selection currently is.
6. Move the 4-D encoder one step to the right to put the focus (the brackets) on the All Sub-
Types label that just appeared, and turn (or press and turn) the encoder to select the
Snare sub-type.
7. Move the 4-D encoder one more step to the right to put the focus on the new All Sub-
Types label that just appeared, and turn (or press & turn) the encoder to select the Side
Stick sub-type.
8. Move the 4-D encoder another step to the right to put the focus on the Results list.
9. Press and hold SHIFT + Button 8 to activate PREHEAR.
10. Turn the 4-D encoder to scroll through all side stick Samples.
11. Once you have found a suitable side stick Sample, press the 4-D encoder to load it into
the Sound slot currently selected (the one triggered by pad 6).
Building Your Own Drum Kit
Customizing Your Drum Kit
MASCHINE - Getting Started - 53