Installation Manual

6. Scroll down the Result list and double-click EK-TL A Kit to load this drum kit into Group

3.1.2 Loading a Drum Kit from the Factory Library Using the Controller

On your controller, do the following:

1. Press button A on the left of your controller to select the first Group slot. This is where

you are going to load the drum kit. Button A should be lit to indicate that it is selected.

2. Press the BROWSER button at the top left of your controller.

3. Press Button 1 or Button 2 above the displays to select GROUPS.

4. Check that Button 4 above the displays is not fully lit and that the USER label under-

neath is not highlighted; if necessary, press Button 4 to disable it.

5. Move the 4-D encoder to the left or to the right in order to put the focus (indicated by the

brackets) on All Types.

6. Press and hold the 4-D encoder to view which Group types are available.

7. While holding the 4-D encoder, turn it to select Kits.

First Steps

Loading a Drum Kit from the Factory Library

MASCHINE - Getting Started - 36