Installation Manual

→ The next time you select a new Scene/Section or group of Scenes/Sections for looping, the
switch will happen on the next division selected here.
► To enable/disable the Retrigger setting, click the Performance Grid menu in the Header
and select Retrigger from the menu.
→ The next time you select a new Scene/Section or group of Scenes/Sections for looping, the
new loop will start from the beginning of the first Scene/Section (Retrigger enabled) or
from the same position as where it left the current Scene/Section (Retrigger disabled).
11.1.2 Jumping to Other Scenes using the Controller
In Ideas view the Perform Grid and the Retrigger controls the setting for jump between Scenes
and in Song view it sets the grid for the jump between Sections.
To set the Perform Grid and the Retrigger settings:
1. Press ARRANGER.
2. Press SHIFT + Button 1 or 2 to select Ideas view or Song View.
3. Press and hold FOLLOW (Grid) to enter Grid mode (or pin it by pressing FOLLOW (Grid) +
Button 1).
4. Press Button 2 to select PERFORM.
5. Press a pad to select the desired value, for example pad 9 (for 1/4, a quarter note).
Playing Live
Performing with Scenes and Sections using the Pads
MASCHINE - Getting Started - 149