User Manual

16.1.3.2 Jumping to Other Scenes using the Controller
In Ideas view the Perform Grid and the Retrigger controls the setting for jump between Scenes,
and in Song view it sets the jump between Sections.
Setting the Perform Grid and Retrigger Settings
To set the Perform Grid and the Retrigger settings:
1. Press SCENE to select Scene mode or SHIFT + SCENE (Section) Section mode.
2. If you want to set the Perform Grid and the Retrigger settings for Scenes, select Scene
mode, for Sections, select Section mode.
3. Press SHIFT + FOLLOW (Grid) to enter Grid mode.
4. Use the Arrow buttons to select Perform.
⇨ In the display you see the current Scene/Section Sync value. The default value Scene/
Section means that the next time you select a new Scene/Section or loop range, the
switch will happen once the current Scene/Section has played to the end.
5. Turn the Encoder to select the desired value, for example 1/4 (quarter note).
→ The next time you select a new Scene/Section or loop range, the switch will happen on
the next quarter note.
Adjusting the Scene Retrigger Setting
To adjust the Scene Retrigger setting:
1. Press SCENE (Section) to select Scene mode.
2. In the display you see the current Retrigger value (Off by default).
3. Turn the Encoder to select On.
→ The next time you select a new Section or loop range, it will start from the beginning.
Adjusting the Section Retrigger Setting
To adjust the Section Retrigger setting:
Working with the Arranger
Arranger Basics
MASCHINE MIKRO - Manual - 680